亚洲一区日韩一区欧美一区a,最新地址四虎www4hutv,欧美日韩在线一区,一区二区三区高清不卡

kimray凱姆鐳氣體調節器結構分類特性

kimray凱姆鐳氣體調節器感應線保護器
作為可調節的自復位限壓裝置，可以保護儀表免受過度加壓和隨后的損壞。 旨在保護高壓調節器上的飛行員。 當超過300 psig的可調節限制時，阻塞感測線或給設備提供壓力。 進口壓力低于極*重新打開。
kimray凱姆鐳氣體調節器結構分類特性

Supply Gas Regulator

For pressure-reducing service in which a supply of consistent pressure is required for pneumatic instruments and pilot-operated controllers.

Sense Line Protector

As an adjustable, self-resetting, pressure-limiting device to protect instrumentation from over pressurization and subsequent damage. Designed to protect pilots on high-pressure regulators. Blocks the sense line or supply pressure to a device when it exceeds the adjustable limit of 300 psig. Reopens when inlet pressure drops below the limit.

Closure for Pressure Vessel Access Opening

Companion Flange Set

Provides for installation of flanged valves in a threaded piping system.

Drain Valve

For use on Kimray Drip Pots or other small vessels that need periodic manual draining

Drip Pot

For removing moisture from gas or air before it flows into instrumentation where dry gas/air is required

Filter

For use with Kimray Pilots to help prevent particle-caused system malfunction and wear

Filter Pop Valve

I/P Transducer

In-Line Check Valve

Pneumatic Solenoid

For electrical control of a pneumatic signal, commonly used to open and close a motor valve.

Air Motor

Commonly used to operate shutters on air cooled heat exchangers and similar equipment, but it can be used wherever linear movement produced by a changing pneumatic signal is required.

Cover Bolt Set

Bolts, Nuts, and Gasket needed to mate flanges

Mini Scrubber

Extracts instrument-quality gas from a wet gas line while the moisture stays in the line. No draining needed!

kimray凱姆鐳氣體調節器結構分類特性